STRUKTOL® SU 135A

Família genérica: Additive -- Compatibilizer / Adhesion Promoter • Fornecido por: Struktol

Two basic types of sulfur are used for rubber compounding, i.e. ordinary ground sulfur called "soluble sulfur" because of its solubility in carbon disulphide (CS2), and the so-called "insoluble sulfur" which is insoluble in CS2.

This characteristic of the sulfur types is paralleled by their solubility in rubbers: insoluble sulfur is completely insoluble in rubber while ground sulfur is in part soluble. This solubility depends upon temperature and excessive sulfur crystallizes from a compound mixed at higher temperatures. A grayish sulfur bloom appears on the green compound followed by small sulfur crystals, which can no longer be dispersed in the rubber compound.

When using insoluble sulfur, blooming from the green compound can be avoided. While ordinary ground sulfur is easily incorporated/dispersed in most rubber compounds, insoluble sulfur can give rise to problems. Owing to static electricity of this type agglomerates are formed which are only partially dispersed. The specialty dispersing agents contained in Struktol coated sulfurs effect a fast incorporation and optimum sulfur dispersion. Static electricity is minimized. The dispersing agents used are non-discoloring and have no influence on the cure rate.

In STRUKTOL® SU 135A, part of the sulfur is present in the soluble state. The ratio of insoluble sulfur to soluble sulfur is well balanced so that in most applications STRUKTOL® SU 135A can offer advantages like insoluble sulfur itself. Blooming can, in particular, be avoided at low sulfur dosages or in compounds that dissolve sulfur to an acceptable extent. When using insoluble sulfur it is important to recognize that this form reverts to soluble sulfur at elevated temperatures, i.e. it should be admixed at temperatures below the critical reversion point (80°C). This also applies to any further processing of the finalized compound. It is also important to note that the reversion of insoluble sulfur is not only promoted through temperature, but also through inorganic bases (amines). Special attention must be paid to the accelerator system in compounding and care should be taken that activators are not too alkaline.

Propriedades gerais

Acesse os detalhes completos da ficha de dados de STRUKTOL® SU 135A quando você criar sua conta gratuita no Prospector. Você encontrará informações completas sobre especificações físicas, mecânicas e de dureza

Status do material

Comercial: Ativo

Documentos

Technical Datasheet (English)

Baixar o documento

Disponibilidade

África & Oriente Médio, América do Norte, América Latina, Ásia/Pacífico, Europa

Outras propriedades

Additives Category, Recommended for Use In, Formas, Densidade

Access 4 properties in Additives. Create your free account or sign into Prospector.

Processamento

Encontre informações de processamento específicas para STRUKTOL® Plastic Additives, além de informações gerais para a família genérica Additive -- Compatibilizer / Adhesion Promoter. Inscreva-se ou Faça login para mais informações.