Escoat® P-30 Solids is a non-silicone product especially produced and widely used as the industry standard for pressure sensitive labels, film and tapes. Its high degree of purity, quality and very tight melting point range offers superior properties and performance to critical users.

Applications: Escoat® P-30 Solids provides superior release properties and prevents delamination or tearing when applied to the backing on the side opposite the adhesive. It has been extensively tested and is widely approved for use with pressure sensitive tapes such as polypropylene, polyester, polyethylene, cellophane, duct tapes and other substrates that require unwinding ease. May also be used for foil and paper.

Advantages:

• Extremely narrow melting point range (+3°C) assures consistent release properties. Listed on the certificate of analysis.

• Release effects remain stable after oven aging.

• Cost efficient. Requires a lower quantity than silicone release coatings. 0.01 to 1.0 grams of Escoat® P-30 Solids for one square meter of film is sufficient. Excellent release can be obtained using between 0.3-2.0% solids material in toluene, depending on film, coating equipment and desired release levels. Only needs a near-monomolecular film.

• 100% dry powder.

• No fire hazard or special red-label storage area required for Escoat® P-30 Solids dry powder.

• One step dilution process. Properly diluted solution will not gel.

• Does not require high temperature processing that is typically needed for silicone coatings.